Example of Moldflow analysis - Ideal Tech, Inc.
Case show of our previous moldflow simulation projects. Case Show. Some of our Moldflow analysis projects. Warpage. Filling Time. Runner Balance. Fiber Orientation. Injection Pressure. Cooling Design. Temp at Flow Front. Deflection Result. Sink Mark. Coolant Temperature.
Select nodes. Fix them versus X, Y or Z. Specify: “Use constraints in: Warp Analysis” (Generally, these references are defined in the plan of the part). Launch the warp analysis and compare the results. If Moldflow shows one of the references is in a deformed area, you should change it and launch another Warp analysis.
One of the analysis that is commonly performed during final part design is a computational flow analysis of the filling and material flow into the tool cavity. Commonly referred to as a mold flow analysis, named after the software product, Autodesk MoldFlow, used to perform the analysis. However, there are several competitive software platforms.
If I change the pressure, Mold temperature or melt temperature injection time or even material, each time wapage result is same.How do I have different warpage results for different process conditions?I have disabled agregation for 3D warpage analysis.
In-mold constraint effect analysis. Before the part is ejected, the deformation of warpage has been developed inside the mold. However, it cannot shrink and deform freely due to constraints by the rigid mold; Calculate the part warpage with in-mold constraint to enhance the analysis accuracy.
This warpage analysis or warpage simulation takes into account all effects from the preceding process phases (mold temperature control, filling phase, packing phase, shrinkage). In the warpage analysis of the plastic component, we take into account the fiber orientation of fiber-reinforced materials and thus show anisotropic shrinkage and warpage.
Journal of Biomimetics, Biomaterials and Biomedical Engineering Materials Science. Defect and Diffusion Forum.